Below you'll find a list of all posts that have been categorized as “Industrial Water”
Construction of a new combined cycle power plant in Middletown, OH required 3 pump stations for the operation of its HRSG system. Middletown Energy Center uses natural gas and HRSG to generate power, this process requires significant amounts of water for operation.
Duke Energy replaced the Dan River Steam Station with a new gas fired power plant and needed a new pump station to handle medium flows of blow down water from the heat recovery steam generator.
BAE Systems, Inc. needed a new pumping system that could handle medium flows of industrial wastewater that was also skid mounted.
Utica East Ohio Midstream needed a new pump stations to handle low flows of stormwater runoff at its new Kensington Plant in Ohio. To responsibly contain potentially hazardous stormwater from the topsoil, this pump station was designed with a double-wall fiberglass wet well with interstitial leak detection. The pumping system also included corrosion resistant components and sensors due to the potential presences of LNGs in the stormwater runoff. Pumps were engineered with 7.5 hp Ebara pumps in a duplex configuration, and a UL listed control panel was supplied with added cable lengths for installation outside of NFPA classified spaces near the pump station.
This package lift station was configured to handle low flows of industrial process water used for nuclear power generation. This lift station was one of the earliest systems to be installed during the construction of two new reactors at the plant. Submersible grinder pumps in a duplex configuration and a below grade valve assembly comprise the principal mechanical operations of the station. An outdoor control panel utilizes floats for primary liquid level-sensing, and an autodialer for communications and alarm notification.
